ATX - 1 x Processor Support - 32 GB DDR3 SDRAM Maximum RAM - CrossFireX Support - Serial ATA/300, Serial ATA/600 RAID Supported Controller - 2 x PCIe x16 Slot - 2 x USB 3.0 Port - HDMI
- Support for Intel® Core™ i7 processors/Intel® Core™ i5 processors/ Intel® Core™ i3 processors/Intel® Pentium® processors/Intel® Celeron® processors in the LGA1155 package
- Intel® Z77 Express Chipset
- 4 x 1.5V DDR3 DIMM sockets supporting up to 32 GB of system memory
- Dual channel memory architecture
- Support for DDR3 2400(OC)/1600/1333/1066 MHz memory modules
- Support for non-ECC memory modules
- Support for Extreme Memory Profile (XMP) memory modules
- 1 x D-Sub port
- 1 x DVI-D port, supporting a maximum resolution of 1920x1200
- 1 x HDMI port, supporting a maximum resolution of 1920x1200
- 1 x DisplayPort, supporting a maximum resolution of 2560x1600p
- Realtek ALC898 codec
- Support for X-Fi Xtreme Fidelity® and EAX® Advanced HD™ 5.0 technologies
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for S/PDIF Out
- 1 x Atheros GbE LAN chip (10/100/1000 Mbit) (LAN1)
- 1 x Intel GbE LAN chip (10/100/1000 Mbit) (LAN2)
- 1 x PCI Express x16 slot, running at x16 (PCIEX16)
- 1 x PCI Express x16 slot, running at x8 (PCIEX8)
- 1 x PCI Express x16 slot, running at x4 (PCIEX4)
- 3 x PCI Express x1 slots
- 1 x PCI slot
- Support for AMD CrossFireX™ / NVIDIA SLI technology
- 2 x SATA 6Gb/s connectors (SATA3 0/SATA3 1) supporting up to 2 SATA 6Gb/s devices
- 4 x SATA 3Gb/s connectors (SATA2 2~5) supporting up to 4 SATA 3Gb/s devices
- 1 x mSATA connector
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
- 2 x Marvell 88SE9172 chips
- 3 x SATA 6Gb/s connectors (GSATA3 6/7/8) supporting up to 3 SATA 6Gb/s devices
- 1 x eSATA 6Gb/s connector on the back panel supporting up to 1 SATA 6Gb/s device
- Support for RAID 0 and RAID 1
- Up to 2 USB 3.0/2.0 ports (available through the internal USB headers)
- Up to 6 USB 2.0/1.1 ports (2 ports on the back panel, 4 ports available through the internal USB headers)
- Chipset + 2 VIA VL810 Hubs:
- Up to 8 USB 3.0/2.0 ports (4 ports on the back panel, 4 ports available through the internal USB headers)
- Up to 2 IEEE 1394a ports (1 port on the back panel, 1 port available through the internal IEEE 1394a header)
- 1 x 24-pin ATX main power connector
- 1 x 8-pin ATX 12V power connector
- 1 x PCIe power connector
- 5 x SATA 6Gb/s connectors
- 4 x SATA 3Gb/s connectors
- 1 x mSATA connector
- 1 x CPU fan header
- 4 x system fan headers
- 1 x front panel header
- 1 x front panel audio header
- 1 x S/PDIF Out header
- 3 x USB 3.0/2.0 headers
- 2 x USB 2.0/1.1 headers
- 1 x Clear CMOS jumper
- 1 x Trusted Platform Module (TPM) header
- 1 x power button
- 1 x reset button
- 1 x Clear CMOS button
- 1 x heatsink LED power connector
- 1 x BIOS Switch
- Voltage Measurement Points
- 1 x D-Sub port
- 1 x DVI-D port
- 1 x optical S/PDIF Out connector
- 1 x HDMI port
- 1 x DisplayPort
- 1 x eSATA 6Gb/s connector
- 4 x USB 3.0/2.0 ports
- 2 x USB 2.0/1.0 ports
- 1 x IEEE 1394a port
- 2 x RJ-45 ports
- 6 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker Out, Line In/Mic In, Line Out)
- ATX Form Factor; 30.5cm x 24.4cm
Some Intel® Core™ processors require a graphic card.
Due to Windows 32-bit operating system limitation, when more than 4 GB of physical memory is installed, the actual memory size displayed will be less than 4 GB.
The DVI-D port does not support D-Sub connection by adapter.
For optimum performance, if only one PCI Express graphics card is to be installed, be sure to install it in the PCIEX16 slot.
The PCI Express x16 slot supports up to PCI Express 2.0 standard when an Intel 32nm (Sandy Bridge) CPU is installed.
The PCIEX8 slot shares bandwidth with the PCIEX16 slot. When the PCIEX8 slot is populated, the PCIEX16 slot will operate at up to x8 mode.
The PCIEX4 slot is available only when an Intel 22nm CPU is installed.
The PCIEX4 slot shares bandwidth with the PCIEX8 and PCIEX16 slots. When the PCIEX4 slot is populated, the PCIEX16 slot will operate at up to x8 mode and the PCIEX8 will operate at up to x4 mode.
The PCIEX16, PCIEX8 and PCIEX4 slots conform to PCI Express 3.0 standard.
All PCI Express x1 slots conform to PCI Express 2.0 standard.
The SATA2 5 connector will become unavailable when the mSATA connector is installed with a solid state drive.
When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance of the RAID set may vary depending on the devices being connected.
In Windows XP, the Intel USB 3.0 ports and VIA VL810 HUB can support up to USB 2.0 transfer speed.
Due to a Windows 7 limitation, please connect your USB device(s) to the USB 2.0/1.1 port(s) before the Intel USB 3.0 controller driver is installed.
|
